Table of Contents
Advertisement
BJC-5000
3. GREASE APPLICATION
Use the special tool to apply the grease at the points and amounts shown below.
Carriage Guide Frame Rear Surface
(Evenly apply 30 to 50mg of
grease on the entire surface.)
Carriage Shaft
(Evenly apply 300 to 500mg of grease
on the entire surface.)
Sliding Section of Platen Gear
(Approx. 22 to 46mg)
Shaft Sliding
Section Surface
(Approx. 12mg)
Sliding Section
with LF Roller
(Approx. 20mg)
Sliding Section with Chassis
(Approx. 20 to 40mg)
Figure 5-1 Grease Application Points
Sliding Section with Feed Roller
(Approx. 20 to 40mg)
5-3
Part 5: Maintenance
Cross-Sectional View of
Gear and Sliding Section
(Approx. 22 to 46mg)
Sliding Section of
Slide Lever
(Approx. 18 to 36mg
each at 2 locations)
Sliding Section of
Purge Unit
(Approx. 40 to 60mg)
Sliding Section
with Chassis
(Approx. 20mg)
Advertisement
Table of Contents
