Table of Contents
Advertisement
BJC-5000
The errors listed in Table 3-2 are described below.
Errors that can be corrected by a user
1) Feed paper error
The paper cannot be fed properly even by the paper feed operation.
Corrective action: Load the paper and press the RESUME button .
2) Paper jam error
The paper cannot be ejected even by the paper eject operation.
Corrective action: Remove the paper and press the RESUME button .
3) Left-head recognition error
Left side BJ cartridge failure or incompatible BJ cartridge.
Corrective action: Install the designated BJ cartridge.
4) Right-head recognition error
Right side BJ cartridge failure or incompatible BJ cartridge.
Corrective action: Install the designated BJ cartridge.
5) High head temperature warning (during head replacement)
The head temperature is found to be too high when BJ cartridge replacement is
attempted. (At this time, the carriage will not move to the replacement position.)
Corrective action: Leave the printer to cool down for a while and then press the
RESUME button . Or, close the front cover once and then open it again.
6) Waste ink full warning
The total waste ink amount recorded by the EEPROM is approaching the specified
limit.
Errors that cannot be corrected by a user
Corrective action: Press the POWER button and turn off the printer.
7) Home position error
The home position of the carriage cannot be detected.
8) Cleaning error
The head cleaning or capping detection at the capping position is irregular.
9) Sheet feeder error
The initial position of the pick-up roller cannot be detected.
10) Temperature sensor error
The reading of the temperature sensor (TH1) on the logic board is irregular.
11) Waste ink full error
The total waste ink amount recorded by the EEPROM has exceeded the specified
limit.
12) Head temperature error
The temperature in the BJ cartridge has exceeded the specified limit.
13) Sub-heater error
The sub-heater in the BJ cartridge is not operating properly.
14) BJ cartridge not found error
The printer cannot detect the BJ cartridge. Only the BJ cartridge replacement
operation is detected.
15) EEPROM error
The EEPROM check has recognized some kind of irregularity.
16) ROM error
The ROM check fails when the AC power cord is plugged in (during the initializing
operation). (At this time, the indicator may not light to indicate the error.)
3-15
Part 3: Operating Instructions
Advertisement
Table of Contents
