CHAPTER 3 EXPOSURE SYSTEM
3.
Routing the Scanner Drive Cable
a.
Before Starting the Work
Prepare the following:
• Mirror positioning tool
• Cable clip
• Adhesive tape
1) Set the mirror positioning tool as shown.
2) Prepare about five strips of adhesive tape
(each one about 20
3) Remove the copyboard glass.
(See Chapter 7.III.C.1. "Removing the
Copyboard Glass.")
4) Disconnect the connectors (J101, J131)
[1] from the DC controller PCB.
3-18
COPYRIGHT © 1999 CANON INC.
50 mm).
CANON NP6512/6612/7120/7130/7130F REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 3-307
[1]
Figure 3-308