Canon NP6512 Service Manual page 132

CHAPTER 4 IMAGE FORMATION SYSTEM
8) Open the machine's top unit farther, and
hold it in place with the handle of a screw-
driver (about 30 mm in diameter).
9) Remove the four screws [3], and discon-
nect the connector [4]; then, detach the
blanking exposure unit. [5].
Caution:
When mounting the blanking exposure
unit, check to make sure that the blank-
ing exposure unit PCBs are at the ex-
treme ends and that the lens is positioned
at the farthest left (141% position).
4-40
COPYRIGHT © 1999 CANON INC.
[3]
CANON NP6512/6612/7120/7130/7130F REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-309
[4]
[5]
Figure 4-310
Lamp PCBs
Figure 4-311