Canon NP6512 Service Manual page 54

Hide thumbs Also See for NP6512:
Table of Contents

Advertisement

CHAPTER 3 EXPOSURE SYSTEM
4.
Controlling the Copying Speed
The machine uses a halogen lamp for scanning, and the heat of the lamp increases the tempera-
ture of the copyboard.
To prevent possible overheating of the copyboard glass, the temperature of the scanner is
monitored by a thermistor (TH2); if its reading reaches 37.5°C or higher, the copying speed is
reduced to 6 cpm.
If this mechanism turns on during continuous copying, it remains on until the end of the copy-
ing job.
At the end of copying, if the reading of the thermistor is 34.5°C or higher, the No. 1 mirror
mount is moved forward 105 mm from the home position and stopped, thereby lowering the tem-
perature of the copyboard fast.
Reference:
While the copying speed is controlled to 6 cpm, the speed of the reverse movement of the
scanner is reduced to prevent overheating of the copyboard glass. (about 75 mm/sec)
Check timing by thermistor
(TH2)
Main motor (M1)
Pickup clutch solenoid (SL1)
Registration clutch
solenoid (SL2)
Scanner
I: When the registration clutch solenoid (SL2) is off, the pickup clutch solenoid is turned off to
prevent overheating of the pickup clutch solenoid (SL1).
II: By the time the Copy Start key is pressed or the power switch is turned off and then on again
next time, the scanner is moved to and stopped at 105 mm forward from the home position.
3-6
COPYRIGHT © 1999 CANON INC.

Switching to 6-cpm copying speed
SCRV SCFW
SCRV
37.5˚C or higher
Figure 3-106
CANON NP6512/6612/7120/7130/7130F REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
SCFW
SCRV
SCFW
I
SCRV LSTR STBY
34.5˚C or higher
II

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Np6612Np7130Np7130fNp7120

Table of Contents