Canon NP6512 Service Manual page 298

CHAPTER 11 TROUBLESHOOTING
e-2. Routing the Scanner Drive Cable
1. Before Starting the Work
Prepare the following:
• Mirror positioning tool (FY9-3009)
• Cable clip (FY9-3017)
• Adhesive tape
1) Set the mirror positioning tool as shown.
2) Prepare about five strips of adhesive tape (each one about 20 x 50 mm).
3) Remove the copyboard glass.
(See Chapter 7.III.C.1. "Removing the Copyboard Glass.")
4) Disconnect the connectors (J101, J131) [1] from the DC controller PCB.
11-12
COPYRIGHT © 1999 CANON INC.
Figure 11-211
[1]
Figure 11-212
CANON NP6512/6612/7120/7130/7130F REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)