Canon NP6512 Service Manual page 321

4. Adjusting the Original Leading Edge Stop Position
You must first correct original skew and adjust the rear/front original stop position before
adjusting the original leading edge stop position.
1) Obtain a sheet of A4 or LTR white copy paper, and draw two lines as indicated.
• The sheet will be used as a test sheet.
2) Remove the screw, and remove the ADF controller cover.
COPYRIGHT © 1999 CANON INC.
10mm
A4/LTR copy papper
Figure 11-251
Screw
Figure 11-252
CANON NP6512/6612/7120/7130/7130F REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
ADF controller cover
11-35