Page 1
(USA and Canada) PT-P710BT Quick Setup Guide (English) Please read this guide, including all Precautions, before using this label printer. After reading this guide, keep it in a safe place. Supplies...
Safety Precautions Follow these guidelines to avoid the risk of heat generation, smoking, explosion, fire, or injury. DANGER Rechargeable Li-ion Battery WARNING Rechargeable Li-ion Battery Label Printer and USB Cable...
Safety Precautions (cont) CAUTION Rechargeable Li-ion Battery Label Printer and USB Cable General Precautions Label Printer, Tape Cassette, or USB Cable...
Page 6
4. Charge the Battery 5 V DC, 0.5 A – 2 A 5 V DC, 0.5 A – 2 A Notes on Using the Rechargeable Li-ion Battery Rechargeable Li-ion Battery Characteristics...
Page 7
5. Turn Power On or Off To print from your Mobile Device, go to Step 6. To print from your Computer, go to Step 8. 6. Print from Your Mobile Device Brother iPrint&Label P-touch Design&Print P-touch Design&Print Brother iPrint&Label...
Page 8
7. Pair the Label Printer with Your Mobile Device On your mobile device: ® PT-P710BT**** "0000"...
8. Print from Your Computer install.brother and install the printer driver and P-touch Editor by following the on-screen instructions. The following software can Features be selected for installation: Printer Driver Software required to print from a label printer. Label creation software for computers. This...
LED Indications Power Lit/Flashing Condition Flashing Green a computer (0.5 second intervals) Lit for 3 seconds, then Standby off for 1 second Initializing Orange Flashing Cooling (0.5 second intervals) Battery Lit/Flashing Condition Not lit Fully charged Charging Not lit for 3 seconds, Only half the battery charge remains.
Cutter error Restart the label printer. Transfer the program again. Program transfer If the problem is still not resolved, failure contact Brother customer service. Flashing Contact Brother customer service. (0.3 second System error (The flashing pattern may change if you intervals) touch the Power Button.)
Troubleshooting If you need additional help, visit support.brother.com Problem Solution is inserted correctly. ver is securely closed. via Bluetooth. The label printer does not print. not paired with another device. enough to communicate. a microwave oven) are located nearby. from a computer.
There is approximately P-touch Design&Print - Turn Cut the last label : OFF 1 in. / 25 mm of blank Brother iPrint&Label - Turn Chain Printing: ON space added to the left Then print your labels and leave the last label in the label printer margin of each printed until you are ready to print a new label.
Remove Battery for Replacement or Disposal 1. Turn the label printer off. 2. Open the Cassette Cover. 3. Remove the two screws from the Battery Cover using a flat-bladed screwdriver. 4. Remove the battery. appropriate collection point. Be sure to observe all applicable local regulations.
Page 15
200 Crossing Boulevard Bridgewater, NJ 08807-0911, U.S.A. TEL: (908) 704-1700 Product Name: Brother Label Printer Electronic Labeling System Model Number: PT-P710BT Label printer complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Label printer may not cause harmful interference, and (2) label printer must accept any interference received, including interference that may cause undesired operation.
Please call 1-800-8-BATTERY for information on how to recycle this battery. Contact Information Phone: 1-877-BROTHER (1-877-276-8437) Fax: 1-901-379-1210 Customer Service for USA To order supplies and accessories: www.brothermall.com...