Removing And Installing Main Centre Stand; Line Arrangement For Side Stand - BMW K 1100 LT/RS Repair Manual

Removing and installing main centre
stand
•
[RS] Remove lower section of fairing
00 1 510
•
Raise motorcycle with lifting gear,
BMW No. 00 1 510, under the oil sump until
stand is free to move.
•
Disconnect cable clips for side stand line.
1
•
Release retaining screws (1) and detach main
stand together with side stand.
•
Install in the reverse order of removal.
.
L
Note:
The retaining screws are micro-encapsulated and
can therefore not be re-used. Clean thread and
holes. Fit screws with Loctite 243.

Line arrangement for side stand

LT460320
X
Tightening torque:
Main stand to bearing block ......................... 41 Nm
LT460310
LT460330
46.23