Installing camshafts
L
Note:
Note correct identification of camshafts.
Inlet side
: three grooves after thrust bearing
Exhaust side: two grooves after thrust bearing
The camshaft bearing caps are also marked.
•
Inlet side:
odd numbers
Exhaust side: even numbers
The numbers increase from the front (timing end)
•
to the rear.
Oil the camshafts at their bearing points.
•
Tighten the bearing caps uniformly, working from
•
the inside outwards.
Install the thrust bearing (timing end) with chain
•
guide last of all.
X
Tightening torque:
Bearing cap.................................................... 9 Nm
11.43