Table of Contents
Advertisement
G. PRT LU Addr - By entering a G the operator can select which LU's data will go to the printer
attached to the A/S-4's terminal port. Selection of this address is done the same as for the VDU LU
addr above.
H. PRT LU Type - The printer LU type is changed by entering the letter H which causes the LU type to
toggle between type 1 and 3. Type 3 print data is preceded with a Write command followed by a
WCC with the start printer bit set. Type 1 data doesn't have this Write command or WCC in its data.
CURRENT:
Application = SDLC/SNA 3776/77 Batch
VDU = ANSI STD; DEC VT100; Teletype 5410, 5420; Televideo 970,960
Keyboard = STANDARD
Change: Application Options
A-Exit
C-PU Addr=F7
E-XON/XOFF=OFF
G-PRT LU Addr=02
I-End of File=CTL C
K-Precede TRN Ctl Chars
with DLE=YES
M-Card Input Data Only=YES
N-VDU Auto Logon Msg=LOGON
APPLID (SYSA) LOGMODE
(BUF512) DATA (RMT13,,,
CTL \ L163AC00CTL \)
O-PRT Auto Logon Field=L163AC01
P-VDU/PRT Auto Signon Msg=/*SIGNON
Enter Letter:
CHAPTER 6: Power Up and Configuration Menu Options
B-XID=01300FF
D-SDLC Baud Rate=1200
F-VDU LU Addr=01
H-Start of File=CTL B
J-Send FMH-2 to VDU=NO
L-Echo Input=YES
Figure 16
43
Advertisement
Table of Contents
