Skips every other label
(Print quality is good but skips every other label).
•
The label is formatted too close to the top edge of the form.
Leave white space equal to 8-dot rows at the top of the label,
approximately .02" (.5mm).
•
The media is not calibrated (see Chapter 4).
•
If equipped, the Adjustable Media Sensor may need to be
repositioned (see Chapter 3).
•
The media sensor or media sensor circuitry may be
defective, call for service.
Unable to print in rotation 4
•
The characters are formatted outside the dimensions of the
label. Check that the row/column values provide enough
room for the height of the characters or bar code to be
printed.
Prints light on the right side of the label
•
The media width adjustment is set for a narrower media
width than is actually being used (see Chapter 5).
•
The printhead is not properly aligned, call for service.
•
The printhead is not locked down.
Printer fails to turn on
•
A fuse may be blown, call for service.
•
Faulty power supply, replace.
•
A bad power switch may exist on the printer, call for service.
•
A faulty AC wall outlet.
BP-1244/BP-1344
51