Brady BP-1244 Operator's Manual page 43

+
Problem
Description
Tear Mode selected
but label stop
position (present
position) is not far
enough forward.
Tear Mode selected
but label stop
position (present
position) is too far
forward.
FAULT LED
illuminates during
label alignment
BP-1244/BP-1344
Possible Cause
Another present
position has been
determined.
Enabling the
Present Sensor
causes the label
stop position
(present
position) to be
approximately
0.1" behind the
peel bar.
~OR~
The Present
Adjust value is
not correct.
Another present
position has been
determined.
~OR~
The Present
Adjust value is
not correct.
The label supply
is empty
Solution
Disable the Present Sensor.
~OR~
Ensure the host computer is not
providing a Present Distance
shorter than is required for the
Tear Bar.
Use the Menu Setup to modify
the Present Adjust value.
Ensure the host computer is not
providing a Present Distance
longer than is required for the
Tear Bar.
Use the Menu Setup to modify
the Present Adjust value.
Load new label stock
33