Brady BP-1244 Operator's Manual page 23

5. Slide the Internal Media Guide and Internal Media Hub Flange to the
edge of the media.
6. Close the Printhead Carrier Assembly and press down until it locks
into place.
7. Close the Cover and press the 'Feed' button several times to position
the media and ensure proper tracking.
(If the printer does not correctly sense the top of each label it may be
necessary to perform the Calibration Procedure, Section 4.6.)
Note: The printer is factory set to use 4-inch media (and ribbon, if thermal
transfer equipped). When using a different width of media/ribbon,
please refer to Chapter 5.
BP-1244/BP-1344 13