Printhead Replacement - Brady BP-1244 Operator's Manual

5.5 Printhead Replacement

Removal:
Notes: It is recommended that the printhead only be replaced by a certified
repair technician. Always follow proper Electro Static Discharge
procedures when replacing the printhead.
If equipped, it is not necessary to remove the Ribbon Handler
Assembly (if equipped). An access hole in the assembly is provided
for access.
1. Turn off the printer.
2. Loosen the Printhead
Screw until it is free
from the printhead.
Carefully unlatch the
printhead carrier
assembly and remove
the printhead.
3. Remove the printhead
cables from the back
of the printhead.
Replacement:
1. Connect the printhead cable to the new printhead.
2. Position the printhead in the printhead carrier assembly, ensure that
the printhead cable is not pinched, and then tighten the Printhead
Screw.
3. Clean the Printhead (see Section 5.1) and allow it to dry before use.
46 BP-1244/BP-1344