Table of Contents
Advertisement
To start sending.
If the document is sent correctly, once this operation has
been completed, the display will show the message "TX
COMPLETED" for a few seconds and then the initial stand-
by status.
If you have entered any incorrect digits: position the cursor,
using the |/} keys, to the incorrect digit and overwrite it with
the correct one; if you want to delete the number altogether,
press the
key.
If you want to abort the transmission in progress, press
the
key. The fax machine unloads the document from
the ADF and returns to the initial stand-by mode.
If the document to be removed consists of more than one
sheet, before pressing
the others by hand.
T
O HEAR THE DIALLING TONE WHEN
SENDING A DOCUMENT
If these diagrams are not enough:
è
è
read the following instructions:
Place the document in the ADF. The display shows the
default contrast and resolution values: NORMAL and
(standard), respectively.
To change contrast and resolution values, see "To adjust
the contrast and resolution", section "Basic transmis-
sion and reception operations".
To hear the dialling tones. The display shows:
/
On the numeric keypad type the number of the correspond-
ent to whom you want to send the document (max. 32
digits).
To start sending as soon as you hear the correspondent's
fax machine tone.
If the document is sent correctly, once this operation has
been completed, the display will show the message "TX
COMPLETED" for a few seconds.
to unload the first, remove all
è
H
OW TO START AT ONCE
T
O SEND A DOCUMENT WITH THE RECEIVER
RAISED
If these diagrams are not enough:
è
read the following instructions:
Place the document in the ADF. The display shows the
default contrast and resolution values: NORMAL and
(standard), respectively.
To change contrast and resolution values, see "To adjust
the contrast and resolution", section "Basic transmis-
sion and reception operations".
Lift the receiver to engage the line. The display shows:
/
On the numeric keypad type the number of the correspond-
ent to whom you want to send the document (max. 32
digits).
If your correspondent's fax machine is set up for au-
tomatic reception, you will hear the fax machine
signal.
If it is set up for manual reception, the correspondent
himself will answer so you can ask him to press the start
key on his fax machine, after which you will hear the fax
machine signal.
To start sending.
If the document is sent correctly, once this operation has
been completed, the display will show the message "TX
COMPLETED" for a few seconds and then the initial stand-
by status.
If you forget to hang up after completing the transaction, the
fax machine will emit a beep to prompt you to hang up.
è
è
XI
Hide quick links:
Advertisement
Table of Contents
