Direct Switching Of The Linked Display; 1Switching A Specific Display In/Out Standby - Barco R9841020 Cine VERSUM Master Installation Manual

Message
Command sent to display
Menu 14-10
Recap
If the status of a display is On, via the display settings menu the display can be switched into the standby mode. If the status of a
display is Standby, then the display can be switched to the operation mode.
For a display with status 'standby', counteracting these status can be made using the jog dial on the Cine VERSUM Master or via
the on-screen of an active display.

14.2 Direct Switching of the Linked Display

14.2.1 Switching a specific display In/Out standby
Make sure the Remote Control suits the address of the display you desire to switch In or Out standby.
How to switch one or more displays To or Out standby mode
1. Program the Remote Control with the address of the display you desire to switch In or Out standby (Module Address Read
out/Change, page 93).
2. Point the Remote Control to the respective display.
3. Press a few seconds the standby key on the Remote Control. (image 14-1)
The respective display switches into the standby mode.
4. Press a few seconds the standby key on the Remote Control again to restart operation.
Image 14-1
Standby key
R5976468 CINE VERSUM SYSTEM 03112003
14. Switching linked displays To and Out Standby
91