Barco R9841020 Cine VERSUM Master Installation Manual page 35

Controls function description
Ref. Function
1 Function keys
2 ADJ (Adjust key)
3 Address key
4 * key
5 PAUSE
6 Standby key
7 MUTE
8 ?
9 Digit keys
10 Audio controls
11 Picture controls
12 PHASE
13 FREEZE
14 TEXT
15 ENTER
16 Cursor keys
17 EXIT
18 RC operation indication
Table 5-5
R5976468 CINE VERSUM SYSTEM 03112003
Description
To position the PIP image in the displayed image.
Toggle key to enter or to exit the adjustment mode.
To match the address of the RCU with the Cine VERSUM Master (number between
0 and 9).
Selecting the aspect ratio of the displayed image to the source.
To blank the image of the linked displays
To power up/down the Cine VERSUM Master and separately the displays in the link.
no use
no use
Allow direct input selection and address setting
no use
Allow to optimize the picture reproduction (Attention: Sharpness control function is
NOT implemented)
Allow to remove image instability
Press to freeze the image
Press to remove all on screen display when adjusting picture (Handy when adjusting
picture during a meeting). Press key again for reactivation.
Press to start the adjustment mode, confirm an adjustment or selection in the
adjustment mode. Press again to leave the adjustment mode.
Allow menu selections in the adjustment mode.
Press to leave the adjustment mode via scrolling upwards in the menu structure.
Lights up when a key on the remote control is pressed (Visual indication of remote
control operation – Battery check).
5. Location of Controls
31