Assembly - Ryobi TSS101L Operator's Manual

UNPACKING
This product requires assembly.
 Carefully lift saw from the carton by the carrying handle and
the saw base, and place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with your
legs, not your back, and get help when needed.
 This saw has been shipped with the saw arm secured in the
down position. To release the saw arm, push down on the
"D" handle, cut the tie-wrap, and pull out on the lock pin.
 Lift the saw arm by the handle. Hand pressure should remain
on the "D" handle to prevent sudden rise upon release of
the tie wrap.
 Inspect the tool carefully to make sure no breakage or dam-
age occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
 The saw is factory set for accurate cutting. After assembling
it, check for accuracy. If shipping has influenced the settings,
refer to specific procedures explained in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories
not recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental start-
ing and possible serious personal injury.
trace holeS
at theSe locationS
For hole Pattern

ASSEMBLy

Do not start the compound miter saw without checking for
interference between the blade and the miter fence. Serious
personal injury or damage to the blade could result if it
strikes the miter fence during operation of the saw.
This saw can tip over if the saw head is released suddenly
and the saw is not secured to a work surface. ALWAYS
secure this saw to a stable work surface before any use to
avoid serious personal injury.
MOUNTING HOLES
See Figure 8.
Always make sure the compound miter saw is securely
mounted to a workbench or an approved workstand.
Failure to heed this warning can result in serious
personal injury.
The compound miter saw should be mounted to a firm
supporting surface such as a workbench. Four bolt holes
have been provided in the saw base for this purpose. Each
of the four mounting holes should be bolted securely using
3/8 in. machine bolts, lock washers, and hex nuts (not
included). Bolts should be of sufficient length to accommodate
the saw base, lock washers, hex nuts, and the thickness of the
workbench. Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 8. Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tipping,
sliding, or walking is noted, secure the workbench to the floor
before operating.
Saw BaSe
14
WARNING:
WARNING:
WARNING:
trace holeS
at theSe locationS
For hole Pattern
MountinG
SurFace
Fig. 8