Ryobi TSS101L Operator's Manual page 16

WORK CLAMP
See Figure 11.
WARNING:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the fence or the saw table. It also prevents the
workpiece from creeping toward the saw blade. This is very
helpful when cutting compound miters. Depending on the
cutting operation and the size of the workpiece, it may be
necessary to use a C-clamp instead of the work clamp to
secure the workpiece prior to making the cut.
To install the work clamp:
 Place the work clamp shaft in one of the holes located
behind the miter fence. Tighten work clamp knob
securely.
 Rotate the knob on the work clamp to move it up or down
as needed.
TABLE EXTENSIONS
See Figures 12 - 13.
To install table extensions, insert the ends of extensions into
the holes in the sides of the base. Adjust the extensions to
the desired length.
Secure extensions in place by positioning a clamp bracket
under each table extension beneath the miter table. Orient
each clamp bracket as shown in figure 13.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the clamp
bracket and tightens against bracket support on bottom
of miter table, securing clamp bracket against table
extension.
work
ShaFt
knoB
BaSe
ASSEMBLy
work
claMP
Fig. 11
taBle
eXtenSion
Saw Viewed FroM BottoM
BaSe
claMP
Bracket
16
BaSe
taBle
eXtenSion
Fig. 12
claMP
Bracket
Fig. 13