OPERATOR'S MANUAL
MANUEL D'UTILISATION
MANUAL DEL OPERADOR
10 in. SLIDING COMPOUND MITER
SAW WITH LED
SCIE À ONGLETS COMBINÉS
COULISSANTE DE 254 mm (10 po)
AVEC DEL
SIERRA INGLETEADORA COMPUESTA
DESLIZANTE DE 254 mm (10 pulg.)
CON LED
TSS103
TABLE OF CONTENTS
****************
Symbols ..............................................6
Features .........................................9-11
Assembly .....................................13-21
Parts Ordering / Service ..... Back Page
To reduce the
risk of injury, the user must read and
understand the operator's manual
before using this product.
SAVE THIS MANUAL FOR
FUTURE REFERENCE
TABLE DES MATIÈRES
****************
Règles de sécurité scie à onglets ....3-4
Symboles ............................................6
Glossaire ............................................ 8
Réglages ...........................................32
Entretien ......................................33-34
Commande de pièces /
réparation ......................... Page arrière
réduire les risques de blessures,
l'utilisateur doit lire et veiller à bien
comprendre le manuel d'utilisation avant
d'employer ce produit.
CONSERVER CE MANUEL
POUR FUTURE RÉFÉRENCE
ÍNDICE DE CONTENIDO
****************
Reglas de seguridad generales .......2-3
Reglas de seguridad sierra
ingleteadora ....................................3-4
Advertencias de seguridad
adicionales ......................................4-5
Símbolos ............................................6
Aspectos eléctricos ............................ 7
Glosario de términos .......................... 8
Características ..............................9-11
Herramientas necesarias .................. 12
Lista de piezas sueltas ..................... 12
Armado ........................................13-21
Funcionamiento ...........................22-32
Ajustes ..............................................33
Mantenimiento .............................34-35
Pedidos de piezas /
servicio .......................... Pág. posterior
ADVERTENCIA:
Pour
el riesgo de lesiones, el usuario debe leer
y comprender el manual del operador
antes de usar este producto.
GUARDE ESTE MANUAL
PARA FUTURAS CONSULTAS
Para reducir
Need help?
Do you have a question about the TSS103 and is the answer not in the manual?
Questions and answers
Arbor blade bolt does not line up with cutout in housing to remove saw blade
To align the arbor blade bolt with the cutout in the housing on a Ryobi TSS103 to remove the saw blade:
1. Unplug the saw.
2. Raise the saw arm.
3. Use the Phillips end of the blade wrench to loosen (but not remove) the blade bolt cover screw.
4. Rotate the lower blade guard and blade bolt cover up and back to expose the blade bolt.
5. Depress the spindle lock button and rotate the blade by hand until the spindle locks, aligning the bolt with the cutout.
This allows access to loosen and remove the blade bolt.
This answer is automatically generated
Blade guard stuck in the upward position
To fix a stuck blade guard on a Ryobi TSS103:
1. Ensure the saw is unplugged from the power source.
2. Check that the lower blade guard is not obstructed by debris or damaged parts.
3. Manually raise and lower the saw arm to see if the guard retracts and returns properly.
4. Make sure the blade guard is not misaligned or caught on the upper blade guard.
5. If needed, inspect the spring mechanism that retracts the guard for damage or disconnection.
If the lower blade guard still does not move freely, it may require cleaning, adjustment, or part replacement.
This answer is automatically generated