Universal Remote Control; Setting Up Your Remote Control - Haier HL40XSL2b Owner's Manual

Universal Remote Control

Video.
C
Press / / button to select desired video
/
folder, and then press ENTER button to enter the
play interface.
1. Play Time
2. File Name
3. Repeat
D
Press MENU button to display the option list.
1. Play/Pause
2. Repeat
3. Show Info
E
Press the button on the remote control to select the
adjusted item, press ENTER button to confirm.
1 2
USB PLAY/PAUSE STOP REC
REV PREV NEXT
REPEAT
3 4 5 6 7
F
Press EXIT button to return to the previous menu.
Press USB button to exit the USB mode.
Note
Do not remove USB device from the TV until
you have exited the USB mode otherwise you
may damage the USB device.
EN-27 Haier LED HDTV
4. Shuffle On or Off
5. Audio Only
6. Information
4. Picture Mode
5. Screen Mode
1. Play or pause
2 Stop
3. Fast reverse
4. Repeat
5. Fast forward
6. Play previous music
7. Play next music
Universal Remote Control

Setting Up Your Remote Control

After it has been set up properly, your remote control
can operate in six different modes: TV, DVD, VCR,
SETBOX, CABLE or AUDIO.
Note
The remote control might not be compatible
with all DVD Players, VCRs and Cable boxes.
Control Operation
A
Program the Controller to work with your device.
B
Changing device mode by pressing the TV
CABLE, VCR, AUD key. When device is set, related
device LED will be on for 1 second and then be off.
C
Aim the remote at the device.
D
Use the other Controller buttons to operate the
device. Device LED will blink if user presses any key
(if the key has data in current mode.). If the key has
no data, then LED will not blink.
E
Default init status: TV/Haier codeset.
Manually Programming the Control
Check the code no. from the code list.
A
Choose the device you want to program.
B
While Press and holding
key, and device LED will be ON. Keep the status for
about 3 seconds and the LED will blink, indicating
that the Controller is ready for programming, then
release both keys.
C
Led will blink once when you enter a digit key,
indicating the digit key is programmed. If 3 digits are
programmed successfully, device LED will be ON for
about 3 seconds and then blink twice per second.
Then User now can:
A) Try to operate the device by using power key.
B) If operation can be done, press
save current 3-digits code brand to EEPROM and
exiting manually programming mode.
C) Return to beginning of step 3. Reprogram the
control.
, DVD, STB,
ENTER key, press INPUT
ENTER key to