Telephone Customization - Lucent Technologies SPIRIT 2448 Administration Manual

Telephone Customization - 2

If you dialed 2 in STEP 5 on page 13, you began Telephone Customization. The features on the
following pages may be programmed in any order, and you may exit customization at any time,
leaving unchanged features at previously-set values. You may also use Telephone Customization
to check the setting of a feature. You do not have to make changes.
Features are customized by entering a digit, as shown on the following pages, If the digit you
enter is valid, you will hear a confirmation tone, and the indicator light(s) will reflect the new
setting. If the digit you enter is not valid, you will hear the error tone and the system will
remain ready to customize that feature until a valid digit is entered or you exit the feature.
No change will be made until you hear the confirmation tone.
All telephone features are customized on a set-by-set basis, so you must enter the telephone
number before customizing. The changes you make on set 12, for example, will not be made on
set 14, or any other, unless you specifically copy a customizing set-up from one telephone to
another. Making changes via Telephone Customization is not always necessary for all telephones.
You may, for example, want to leave all the telephones except one at the installed setting for
a feature.
EXAMPLE: All of the telephones except set 16 are used by employees who should not be
restricted from placing long distance calls. Set 16, however, is in the lobby, and is used by
company visitors. You might want to set OUTSIDE SERVICE on the lobby telephone
to Toll Restricted, leaving the other telephones Unrestricted.
After customizing a feature, you may do any of the following:
press the FEATURE button to customize another feature
press the STATION button to customize another telephone
press the ENTER ADMIN button to go back to STEP 5 on page 13
press the COPY TO button to copy the customization of this telephone to another telephone
hang up the receiver (or press SPEAKER) to finish customization
During customization, all the buttons on your 24-button set represent line buttons. Numbering
starts at the lower left with line 1 (see illustration, page 15). When you are customizing a
feature that is not changed on a line-by-line basis, the Line 1 indicator light will show the
current status of the feature on that telephone. When you are customizing a feature that is
changed on a line-by-line basis (line selectable), the status of each line of that telephone will show
on the indicator light for that line.
When you are customizing features that require a setting for each incoming line in the system,
you do not have to press the FEATURE button for each line. Press all the line buttons for
which you want the same setting.
EXAMPLE: You are customizing LINE USE PERMISSION and you want to make lines
4, 5, and 6 No Permission and lines 7 and 8 Answer Only.
PROCEDURE: Press FEATURE, dial 2, press line buttons 4, 5, and 6, and dial 1. Press line
buttons 7 and 8 and dial 3.
The indicator light of a selected line button will flash rapidly to let you know which line you
are currently customizing. If you have selected a line and then change your mind and do not
want to customize that line, simply press the line button again.
18 Administration Manual