USING TI 700
PRINTER
Printing Call Handling
Reports
There are two sets of switch settings to check on TI 700
printers. The four pencil switches under the paper
compartment cover must be set as follows (On= Closed;
Off = Open):
•
Switch 1: OFF
•
Switch 2: ON
•
Switch 3: OFF
•
Switch 4: ON
The three rocker switches at the upper right of the
keyboard must be set as follows:
•
UPPER CASE: OFF (Left side of the switch
pressed down)
•
ON LINE: ON (Right side of the switch pressed down)
•
LOCAL COPY: OFF (Left side of the switch
pressed down)
Once the cable is configured and the printer is connected,
perform the following steps to print a report:
NOTE: If any of the report counters exceed 65,535 total,
the counter is reset to 0.
1
Select an outside line and dial a telephone number that
is answered by the MERLIN Attendant.
NOTE: If you are programming from a remote
location using a single-line standard Touch-
Tone phone, enter only one pound (#) sign for
every two pound signs (##) that appear in a
programming command.
2 Wait for an answer.
3 Dial * followed immediately by the authorized caller
code and ##.
Troubleshooting 3 - 7