Barco Coronis 21-inch Installation & user manua Installation And User Manual page 76

Display operation
Rotate the control wheel to select User Controls.
4.
Press the control wheel to switch from "On" to "Off".
5.
Exit the menus.
6.
To enable user controls:
Make sure the on-screen display is not on the screen.
1.
Do not use the control wheel for at least 3 seconds.
2.
Rotate the control wheel 1 step clockwise.
3.
Press the control wheel 2 times.
4.
Rotate the control wheel 1 step counterclockwise. The on-screen
5.
display appears.
Note: Steps 2 to 4 must be performed in maximum 3 seconds.
Rotate the control wheel to select Settings.
6.
Press the control wheel to enter the Settings menu.
7.
Rotate the control wheel to select User Controls.
8.
Press the control wheel to switch from "Off" to "On".
9.
Exit the menus.
10.
76
SETTINGS
DPMS
Power LED
User Controls
EXIT
Figure 27: Settings menu
On
On
Off