How To Change The Baudrate; Automatic Startup; Rs232 Baudrate - Barco RLM G5i Performer R9010320 Owner's Manual

14. Installation menu
The menu item is stored behind the quick access key. The message Quick Access key stored will be displayed.

14.6 RS232 baudrate

How to change the baudrate?

1. Press MENU to activate the menu bar.
2. Press → to select the Installation item. (image 14-14)
3. Press ↓ to pull down the Installation menu.
4. Use ↑ or ↓ to select RS232 baudrate
5. Press → to pull down the menu.
6. Use ↓ or ↑ to select the desired baudrate.
7. Press ENTER to confirm.
Image 14-14

14.7 Automatic startup

What can be done ?
The automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing through the
standby state.
The projector restarts at power resume and recovers the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
C
AUTION
precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
How to enable/disable the Automatic startup?
1. Press MENU to activate the menu bar.
2. Press → to select the Installation item. (image 14-15)
3. Press ↓ to pull down the Installation menu.
4. Use ↑ or ↓ to select Automatic startup .
5. Press → to pull down the menu.
6. Use ↓ or ↑ to enable/disable the automatic startup.
130
:
If the Automatic startup function is enabled one must be aware of the fact that it involves safety
R5976815 RLM G5I PERFORMER 02/06/2006