Barco RLM G5i Performer R9010320 Owner's Manual page 39

A B C
2
3
1
Image 4-7
Stereo jack pin configuration
A tip: Left channel
B ring: right channel
C screen: common (GND)
D external switch
1 Stereo jack
2 Mono jack
The Remote connection uses a standard two wire cable terminated on each end with a 3.5 mm male
(mono/stereo) phone jack.
This cable is not delivered but is available in most electronic or audio shops.
Directly to one of the IR sensors
1. When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line).
The remote control unit will no function properly if strong light strikes the sensor window or if there are obstacles between the
remote control unit and the projector IR sensor. (image 4-8)
IR Sensor (C)
45° 45°
Image 4-8
Remote control to IR sensor
A IR sensor on front
B IR sensor on top
C IR sensor
Optional two way hard-wired remote to XLR input
1. Plug one end of the twisted pare cable with XLR connector in the two way remote. (image 4-9)
2. Plug the other end in the XLR connector on the projector.
R5976815 RLM G5I PERFORMER 02/06/2006
D
1
2
IR Sensor on Front (A)
IR Sensor on Top (B)
4. Getting Started
37