Access Panels; Verifying Transformer Setting - Aquacal WATER SOURCE WS03 Installation Manual

1.5.c Access Panels
DANGER
Deactivate power while routing wiring to control board.
l
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
l
(SunPower)
1.5.d Verifying Transformer Setting
Transformer voltage must be confirmed and set correctly depending on the measured voltage found on the
site. Incorrect settings may cause heat pump damage. The following procedure will allow the installer to set
the heat pump's transformer for the appropriate site voltage.
DANGER
Deactivate power while routing wiring to control board.
l
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
l
WARNING
The information contained in this section is intended for use by qualified technicians, familiar with electrical
l
service-industry safety standards and methods.
Failure to heed the following will result in injury or death.
(Water Source)
Failure to heed the following will result in injury or death.
Failure to heed the following may result in injury or death.
Page - 23