Section 3 - Operation; Indicator Lights - Aquacal AUTOPILOT 110 Quick Start Manual

Page 3

SECTION 3 - OPERATION

Pool
78
Spa
Cooling
POOL
UP
SPA

INDICATOR LIGHTS

LIGHTS
"Pool"
"Spa"
"Cooling"
"Desired Temp"
"Water Temp"
"Heating"
BUTTONS
BUTTONS
"Pool / Spa"
"Up"
"Down"
"Mode"
DISPLAY
MESSAGE
"000"
"ACH"
"COOL"
"HEAT"
"OFF"
"xx°"
FLO
Desired Temp
°
Water Temp
Heating
DOWN MODE
Figure 4
EXPLANATION
Pool Thermostat Selected
Spa Thermostat Selected
Actively Cooling Water
Setting Desired Water Temperature
Actual Water Temperature
Actively Heating Water
EXPLANATION
Select between Pool and Spa
Select to raise temperature set
point or move up in a menu choice
Select to lower temperature set
point or move down in a menu
choice
Select a mode
EXPLANATION
A user lockout code has been
activated.
Auto-Change Over Mode
Cooling Mode
Heating Mode
Unit off
Current Water Temperature
(Example 78°)
No water flow through Heat Pump
SUPPLEMENTAL INFORMATION
Not applicable for Straight Heat models.
SUPPLEMENTAL INFORMATION
Please note – this does not turn off equipment. It only allows a user to
toggle between the Pool thermostat and the Spa thermostat.
Modes available are "ACH", "COOL", "HEAT", and "OFF".
Please note – "ACH" and "COOL" only available on some models.
SUPPLEMENTAL INFORMATION
A numeric code is required before any temperature adjustment can
be entered. Use the "UP" or "DOWN" arrow to enter code, then select
"MODE" to temporarily unlock Heat Pump. If code is unknown, a re-
set option is available in product manual. Manuals can be
downloaded from www.AquaCal.com.
When this mode is active, the heat pump will automatically switch
between heating and cooling modes to maintain a set temperature
point within 3 degrees. Feature available for Heat & Cool units.
Heat Pump is set to cool the water. Feature available for Heat & Cool
units.
Heat Pump is set to heat water.
Heat Pump can be turned off by using "MODE" button or setting
temperature below 45 degrees. Heat Pump will not allow a set
temperature to be programmed until turned on again.
Temperature can be set from 45° F to 104° F. This can be displayed
in Fahrenheit or Celsius depending on programming.
This can be a normal display depending on system settings. See
"Troubleshooting" if needed.
Table 3
Table 4
Table 5