Alpine NVD-V001 SMART MAP PRO Owner's Manual page 34

Point Editing
Memory Point Move
Select "POSITION" and press
4
ENTER.
The position to be corrected is
5
indicated by the reticule icon. Use
the joystick to move the map.
Press ENTER.
6
After displaying the confirmation
message, the memory editing list is
displayed.
Special Settings
Select "SPECIAL" and press
4
ENTER.
The special use list appears.
5
Select the desired item and press
ENTER.
34
L Setting the point to avoid (POINT TO
AVOID)
• This is set when there is a point that you do
not want to be covered by route searches.
Routes are set to avoid roads between
crossroads surrounding that point.
• Five locations can be set. (From X0 to X4
can be displayed on the memory point list.)
L Setting the point to beep (POINT TO
BEEP)
• You can set the system to beep when you
are driving and approaching a point requir-
ing particular care (such as a point where
accidents occur frequently).
• Up to ten locations can be set including the
beep direction points (from B0 to B9).
L Setting the travel direction to beep (BEEP
DIRECTION)
• For details on how to set the direction, see
Page 45 Direction correction.
• A point for the system to beep at and the
direction of travel can be registered to-
gether. For example, you can set the
system to beep near Spandau when travel-
ling from Berlin toward Hannover.
• Up to ten locations can be set as directional
beep points and beep points (from B0 to B9).
L Not used (NO SETTING)
• Use to cancel selected avoid points/beep
points/directional beep points.
6 The special use setting list is
displayed. Press ENTER.
The memory editing list is
7
displayed.