Toshiba e-STUDIO400P Printing Manual page 33

2.PRINTING FROM WINDOWS
There are also 20 custom paper sizes in the [Print Paper Size] box. You can set the custom paper sizes in the
[Others] tab.
P.61 "[Others] tab"
3) Image Scale
Select this check box to enter the scale manually to enlarge or reduce an image. The ratio can be set at between 25
and 400%.
For detailed instructions on how to print with the [Image Scale] setting, see the following page:
P.88 "Fitting images within paper size"
4) Paper Source
This selects a paper source to print a job in the most suitable paper size. The figure on the right indicates the paper
size set for each paper source. When you select a paper source, the chosen one is indicated with a green square in
the figure.
You can select a paper source by directly clicking on the figure on the right.
- Auto — Automatically selects the paper set in this equipment according to the printed document size.
- Drawer 1 — Paper is fed from the 1st Drawer.
- Drawer 2 — Paper is fed from the 2nd Drawer.
- Drawer 3 — Paper is fed from the 3rd Drawer.
- Drawer 4 — Paper is fed from the 4th Drawer.
- LCF — Paper is fed from the Large Capacity Feeder (optional). This cannot be selected if the Large Capacity
Feeder (optional) is not installed.
- Bypass Tray — Paper is fed from the Bypass Tray. When this is selected and print a job, [JOB STATUS] on the
touch panel will blink. Press [JOB STATUS] and check the paper size of the job. Then set the paper and press the
[START] button to print a job.
- External LCF — Paper is fed from the External Large Capacity Feeder (optional). This cannot be selected if the
External Large Capacity Feeder (optional) is not installed.
When you select the bypass tray as a paper source but the orientations of the original and the paper on the
bypass tray differ, the data in the original are rotated for 90 degrees and printed in the same orientation as that
of the original, as long as their paper sizes are the same (this is available only for A4, B5, LT and 16K). For
example, when an original is A4 in a portrait direction but the paper on the bypass tray is A4-R, the data of the
original are printed in A4 in a portrait direction.
The selectable values vary depending on the optional devices installed on this equipment and their
configuration on the [Device Settings] tab.
When paper such as special or tab paper that needs to be fed from the bypass tray is set, [Bypass Tray] may be
automatically selected in the [Paper Source] box, and then a confirmation dialog box may appear.
When the paper size settings on the [Device Settings] tab differ from those in the equipment, the paper source
setting is ignored and the equipment may prompt to set the paper in the bypass tray.
The Large Capacity Feeder (optional) is not available for some countries or regions.
2 PRINTING FROM WINDOWS
Setting Up Print Options 31