Konica Minolta KIP 9900 User Manual page 124

4. The mis-fed media can be seen inside. Check if it is already cut or not.
•
If already cut, remove it and go to the procedure 7.
•
If not cut yet, go to the next procedure 4 for cutting it.
5. Rotate the Cutter Handle for 1 revolution clockwise to cut the roll media.
NOTE
The Cutter Blade needs to be placed at its home position correctly after the above operation.
After cutting the media rotating the Cutter Handle, place the green part inside of the notch.
If red part is seen in the notch, the Cutter Blade is not correctly placed to its home position.
And at this time take care for the following points.
•
Do not rotate the Cutter Handle counter-clockwise. It will damage the Cutter Blade.
•
Do not rotate the Cutter Handle more than once. If it is rotated many times, very small
paper portion will be left in the cutter unit. This will cause the error.
Correct (Green)
Cutter Handle
Incorrect (Red)
3-20 Chapter 3 Error Correction & Maintenance