Table of Contents
Advertisement
7. Using a slit on each drawer, cut off the leading part of roll media with a cutter knife to straighten
the leading edge.
Slit
NOTE
Do not feed any media with tape or adhesive remaining on it. It is recommended to trim
at least one full revolution from the roll when installing a new roll.
8. Insert the leading edge of media between feeding rollers, and rotate the upper feeding roller to
pinch the leading edge (10 - 20mm) with the rollers.
Feeding rollers
NOTE
The Roll Deck 3 only has a positioning hole. (Other Rolls do not have it.)
Feed the roll media until its leading edge comes to appear in the hole, and place the
leading edge at the center of the hole.
Positioning Hole
2-11
Chapter 2
Basic Operations
Advertisement
Chapters
Table of Contents
