Instructions For The User; Overall Dimensions; Installation - Baumatic TS4SS Instruction Booklet

CAREAND MAINTENANCE
Before cleaning the appliance switch off the electrical supply at the
control switch.
Do not clean the appliance surfaces when still hot.
ENAMELLED SURFACES
Clean with a damp cloth using soap and water.
Grease can be easily removed using hot water or a specific cleaning agent
for enamelled surfaces. Do not use abrasive cleansers.
Do not leave any acid or alkaline substances (lemon juice, vinegar, salt,
etc.) on the enamel.
Clean the parts in stainless steel with specific cleaners for stainless steel
surfaces.
These detergents must be applied using a soft cloth.
Cleaning the oven shortly after use can make cleaning easier.
OVEN CLEANING
This oven is not a self cleaning so after using, when the temperature
drops, clean it with hot water and detergent. If the oven is self cleaning,
after using you should only need to wipe off the remaining deposits with
a damp cloth.
Sometimes it is useful to set the empty oven, to the maximum temperature
until it has reached its temperature and when it has cooled down wipe off
the deposits with a damp cloth.
Do not use spray products to clean the fan and the sensor of the thermostat.
Fig. 8
B
C
D
Fig. 10
OVEN DOOR CLEANING
For some models, the oven door can be disassembled for easier cleaning
in the following way: open the oven door fully, rotate the levers "A" into
the correct location on the hinges(Fig.8); lift the door and slip it off(Fig.9);
lay it on a flat surface; unscrew the screw "B" using a screwdriver and
take off the tab "C" (Fig.10); after cleaning you should do the same
operations in reverse to fix the glass "D" and reassemble the door.
OVEN LAMP SUBSTITUTION ( lamp is not covered by the warranty)
Switch off the appliance; unscrew the glass protection cover (Fig.11);
unscrew the lamp and substitute it with another one suitable for high
temperatures (300 C) with the below specification:
Tension 230 V (50Hz)
Power 15 W
Attach E 14
A
Fig. 9
Fig. 11
Replace the glass cover and switch on the appliance.

INSTRUCTIONS FOR THE USER

OVERALL DIMENSIONS

89 9
WARNINGS
Before doing any repairs switch off the electrical supply at the control
switch and close the main gas valve.
The technician is responsible for the correct installation of the appliance
in relation to the current directives.
The appliance must be earthed. The factory is not responsible for damages
to persons, pets or property, if the above directions are not followed.
The technical data is indicated on the data plate placed on the rear of the
appliance. The adjustment requirements are shown on the label stuck on
the packaging and on the appliance.
Do not use the oven door handle to lift or move the appliance, such as
removing it from the packaging.
The appliance is in class 1 or class 2 subclass 1.

INSTALLATION

Your cooker is heavy, so be careful when moving or positioning it. Do not
try to move the cooker by pulling on the doors, handles or control panel.
The cooker is designed to "slot in" between 600mm deep cabinets, spaced
approximately 1000mm apart. It can also be used free-standing, with a
cabinet to one side, in a corner setting or with its back to a wall. However,
it must not be situated with either side closer than 20mm to a combustible
wall or cupboard that is higher than the cooker. It should not be installed
at the end of a run of cabinets if there is a cabinet at immediate right
angles to the cooker door. In case of installation between kitchen units,
their sides must withstand a temperature of at least 85 degrees C.
The wall behind the cooker and 450mm above and across the width of
the cooker, should be an non-combustible material or easy clean surface
such as ceramic tiles. Any overhanging surface or cooker hood should be
at least 750mm (30") above the cooker hob. We do not recommend
positioning the cooker below wall cupboards, as the heat and steam from
the cooker may cause damage to the cupboard and its contents.
The cooker may be located in a kitchen, or a bed-sitting room, but not in
a room containing a bath or shower. The cooker must not be installed in
a bed-sitting room of less than 20m
in a room or internal space below ground level, e.g. in a basement.
min. 50 mm
min.100
8
599
3 . LPG Models must not be installed
min. 50 mm