Instructions For Installation - Baumatic AS9.1AL VALV-B72TCBL- B77TCBL-B40-B78 User And Installation Instructions Manual

CLEANING THE APPLIANCE
Always allow the appliance to cool down before cleaning to avoid a burn injury.
Do not use caustic or abrasive agents, coarse wire wool or hard tools as these can damage the
surface finishes.
Normally, wiping with a soft cloth dampened with hot detergent solution is sufficient but for
stubborn marks the following is recommended:
Vitreous Enamel parts – use only a cleaner that is recommended for this type of material.
Burner Assemblies – remove from the hob and soak for about 10 minutes in hot detergent
solution. Rinse off and dry checking that the burner holes are not clogged, then reassemble in the
correct order.

INSTRUCTIONS FOR INSTALLATION

This appliance must be installed by a competent person in accordance with the current
versions of the following UK (United Kingdom) or ROI (Republic of Ireland)
Regulations and Safety Standards or their European Norm Replacements.
Irish Standard for Domestic Gas Installations
NOTE: UK law stipulates that gas appliances must be installed and repaired by a CORGI
Registered Installer (all Baumatic Engineers are CORGI Registered).
Gas safety Regulations (Installation & Use)
Building Regulations (issued by the Department of Environment)
Building Standards (Issued by the Scottish Development Department)
IEE Wiring Regulations
Electricity at Work Regulations
BS 6172 Installation of Domestic Gas Cooking Appliances
(if necessary, BS 5482 Installation of Domestic LPG Appliances)
BS 5440 Installation of Flues and Ventilation for Gas Appliances
Baumatic Ltd Installation Instructions
POSITIONING THE APPLIANCE
This appliance is classified as Class 3 and therefore is to be built into a kitchen unit (depending
on size) or 600mm wide worktop, providing the following minimum distance is allowed:
- 700mm between the top surface and the underside of any horizontal surface above it.
- 50mm clearance around the appliance and combustible materials.
The surface finish of any adjacent unit must be capable of withstanding a minimum temperature
of 85°C.
PRE-COMMISSIONING THE APPLIANCE
When unpacked, check that the following parts are included with the appliance:-
•
Baumatic Ltd Instruction and Installation Book
•
Pan Supports
•
Burner Assemblies
•
Adhesive sealing strip and fixing clamps & screws
•
½ BSP Elbow & Seal
•
LPG conversion kit comprising an LPG jet for each burner and a self-adhesive label for
amending Gas Category on the appliance Rating Label.
6