Installation; Preparing Pool Water; Salt & Swim 3C Installation - Hayward Salt & Swim® 3C Owner's Manual

Remove power to the pool filter pump before starting this installation. Installation must be performed
in accordance with Local and NEC codes. The Control Box must be mounted a minimum of 10 ft.
horizontal distance (or more, if local codes require) from the pool, within 3ft from a GFCI outlet, and
within 15ft from where the Cell will be installed. Take care to protect the Cell Cap connector pins
while handling the Salt & Swim 3C unit during installation. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
FILTER
PUMP
FROM
POOL

Preparing Pool Water

To prepare the pool water for Salt & Swim 3C operation, the pool's chemistry must be balanced and
salt must be added. This must be done BEFORE activating the Salt & Swim 3C. Some adjustments
to your pool chemistry may take several hours, so start the procedure well before you intend to oper-
ate the Salt and Swim.
To prepare your pool water, follow the instructions on the included Pool Chemistry Quick Start Guide
and refer to page 8 of this manual.
Adding Salt: Add salt several hours or, if possible, 1 day prior to operating the Salt & Swim 3C . Take
care not to exceed the recommended salt level. Measure salt 6-8 hours after adding to the pool.
NOTE: If the pool does not have new water, add 1 quart (1 liter) of metal remover and 1 quart (1 liter)
of non-copper based algaecide to the pool, per manufacturer's instructions. This ensures a quick,
troublefree transfer to the Salt & Swim 3C system.
Salt & Swim 3C Installation
Follow the step by step instructions located on the Installation Quick Start Guide. Refer to the following
sections for more detailed information.
2
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Installation

Waterproof
GFCI
Outlet
3 Feet
15 Feet
Optional
Vertical
Installation
TO
POOL