Hayward Salt & Swim® 3C Owner's Manual page 7

Position the Vessel in a manner where the Cell can be easily inserted and removed. Secure the
Vessel to the cut pipe by tightening the Nuts as shown below. Handtighten the Nuts to stop, then
continue 1/4 turn more using the included strap wrench. If the Inspection marks can be seen, the
pipe has not been inserted far enough into the Cell Vessel.
Verify that both Cell
Vessel gaskets are in place
Insert Cell
6
Vessel and
hand tighten
Nuts
Use the included strap wrench
to tighten an additional 1/4 turn
7
If so, loosen
Nuts and slide
IMPORTANT:
the pipes further
Inspection
into the Cell
Marks should
Vessel and
not be visible
re-tighten
Remove the foam protector from the SAS-CELL. Fully cover Cell pins with supplied grease. Verify
that the O-ring is attached to the Cell before inserting the Cell into the Cell Vessel as shown.
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS