Hayward Salt & Swim® 3C Owner's Manual page 2

When installing and using this electrical equipment, basic safety
precautions should always be followed, including the following:
READ AND FOLLOW ALL INSTRUC-
•
TIONS
• TO REDUCE THE RISK OF DROWNING FROM HAIR AND
BODY ENTRAPMENT, INSTALL A SUITABLY RATED SUCTION
GUARD TO MATCH THE MAXIMUM FLOW RATE MARKED.
ATTENTION : LES PRISES DASPIRATION DOIVENT ETRE
EQUIPEES DE GRILLES CONVENANT AU DEBIT MAXIMAL
INDIQUE.
• WARNING - To reduce the risk of injury, do not permit children
to use this product unless they are closely supervised at all
times.
• WARNING – Risk of Electric Shock. Connect only to a grounding
type receptacle protected by a ground-fault circuit-interrupter
(GFCI). Contact a qualified electrician if you cannot verify that
the receptacle is protected by a GFCI.
• Do not bury cord. Locate cord to minimize abuse from lawn
mowers, hedge trimmers, and other equipment.
• WARNING – To reduce the risk of electric shock, replace dam-
aged cord immediately.
• WARNING – To reduce the risk of electric shock, do not use
extension cord to connect unit to electric supply; provide a
properly located outlet.
• "CAUTION: To reduce the risk of electric shock, install at least
10 feet (3 meters) horizontally from the inside walls of a pool
or spa/hot tub. Do not use an extension cord." ATTENTION :
MAINTENIR UNE DISTANCE MINIMALE D'UN METRE, MESU-
REE DANS UN PLAN HORIZONTAL, ENTRE LE BASSIN ET
LES APPAREILS ET COMMANDES.
• For Canadian Units: At least two lugs marked "BONDING
LUGS" are provided on the external surface or on the inside of
the supply terminal box or compartment. To reduce the risk of
electric shock, connect the local common bond ing grid in the
area of the hot tub or spa to these terminals with an insulated
or bare copper conductor not smaller than No. 6 AWG.
SAVE THESE INSTRUCTIONS
•
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS