Table of Contents
Advertisement
1.0 INSTALLATION:
1.1 Transporting the Vessel:
The Hayward FLV Series GFPP Duplex Filter should be stored inside factory packaging until product is ready to be installed. The Duplex Filter should be
moved as close to the installation site as possible prior to removing from packaging. The Duplex Filter is shipped as an assembly and is mounted to a
fiberglass grate, or skid, and should be moved using a pallet jack, or forklift (See Figure 1).
After removing the Duplex Filter from packaging, a forklift, or pallet jack, should be used to transport the Duplex Filter to installation site. Care must
be taken not to damage vessels, threads, or basket (inside vessels) with pipe, chain, strap, or other lifting equipment.
Hayward recommends leaving cover and assembly nuts on vessel bodies while moving assembly.
Hayward FLV Series GFPP Duplex Filter requires at least two people to lift or move. Attempting to lift or move the Duplex Filter
1.2 Mounting the Duplex Filter to Floor or Skid:
Hayward FLV Series GFPP Duplex Filter is shipped preassembled to a fiberglass grate, or skid, with fiberglass struts supporting the grate from
underneath. Make sure that the Duplex Filter assembly will be located in an area where the floor is level. The Duplex Filter assembly can be
mounted to the floor by fastening the grate, or struts, to the floor via floor-mounted studs. If floor-mounted studs are used, make sure that
they are of sufficient length to clear the top of the grate and/or strut, as well as allow for the height of the washer(s) and nut that will be
fastened to the studs.
Hayward Flow Control
CAUTION
alone could result in property damage or personal injury.
Vessel A
Inlet Port
Outlet Port
Figure 1: FLV Series Duplex Filter Assembly
(Top and Front Views)
www.haywardflowcontrol.com
In order to protect threads,
Vessel B
1-888-HAY-INDL (1-888-429-4635)
FLV4PDUPIOM Rev A 12/21/2017
Pg. 4 of 10
Advertisement
Table of Contents
