Operation; Controls - Hayward Salt & Swim® 3C Owner's Manual

Controls

The main controls and indicators are shown below.
Illuminates when Cell has reached the end of its expected life.
When this LED indicator is illuminated, there is a problem with
the unit. Refer to the Troubleshooting section of this manual.
Illuminates when unit is waiting for the filter pump to turn on or
is in-between generating cycles as part of normal operation to
maintain selected
Illuminates when unit is actively generating chlorine.
Illuminates when unit is SUPER CHLORINATING.
Illuminates when there is no flow or low flow through the
Cell. The pool filter pump could be in its "off" cycle. If this
is not the case, refer to the Troubleshooting section in
this manual.
Blinks when performing the Flow Switch Calibration
procedure.
Press ( + ) and ( - ) to increase or decrease the chlorine
generation. The DAILY CHLORINE OUTPUT LEDs
above these buttons will indicate the relative amount of
chlorine being generated.
When you have an abnormally high bather load, a large
amount of rain, a cloudy water condition, or any other
condition which requires a large amount of purification to
be introduced, press the
This electronically "super chlorinates" (boosts chlorine
generation output) the water for 24 hours (filter pump must
be on during this time). To cancel
the SUPER CHLORINATING
12
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Operation

DAILY CHLORINE OUTPUT
SUPER CHLORINATING
super chlorinating
button again.
.
button.
, pres s