3Com 3C10122 - NBX Business Telephone Installation Manual page 188

188 C 10: C
HAPTER ONFIGURING
IP T
ELEPHONY
To manually configure channel IP addresses:
1 Log in to the NBX NetSet utility using the administrator username and
password.
2 If you have not already done so, use the Auto Discover feature or manual
configuration to add the T1, E1, or ISDN BRI channels to the
configuration database.
To manually configure IP settings for digital line card ports:
1 Log in to the NBX NetSet utility using the administrator username and
password.
2 If you have not already done so, use the Auto Discovery feature to add
line card ports to the configuration database, System-Wide Settings >
Auto Discovery Settings.
3 Click PSTN Gateway Configuration > Digital Line Cards.
4 Select a line card port from the list by clicking its MAC address, and then
click the IP Settings tab.
5 To assign one IP address manually and have the NBX system assign the
remaining addresses to each successive channel on the card
automatically, enter the first address in the First IP Address box. The
system adds the remaining addresses sequentially when you apply the
changes.
3C10165D E1 cards and 3C10116D T1 cards need only one IP address.
Enter the IP address in the First IP Address box. The Assign Addresses
Individually button does not appear when you are configuring 3C10165D
E1 cards and 3C10116D T1 cards.
6 To assign IP addresses individually on digital line cards other than
3C10165D E1 cards and 3C10116D T1 cards, click Assign Addresses
Individually.
a Specify an IP address for each channel.
b In the Common Subnet Mask and Common Default Gateway fields,
enter IP values that are appropriate for your network.
c Click Ok.
7 In the IP Settings screen, click Apply.
8 Wait 3 minutes for the changes to take effect.
9 Verify your changes.