Connecting The Analog Terminal Adapter - 3Com 3C10122 - NBX Business Telephone Installation Manual

146 C 5: A
HAPTER NALOG
Connecting the
Analog Terminal
Adapter
D
EVICES
See "3Com Telephones"
and licensing requirements.
1 Log in to the NBX NetSet utility using the administrator username and
password.
2 Click
System-wide Settings > Auto Discovery
3 Enable the Auto Discover Other Devices check box.
4 Click Apply.
After you have enabled the Auto Discover feature, connect the Analog
Terminal Adapter (ATA) to the same network segment as the one on
which the NCP resides. To connect the ATA:
1 Connect the AC power converter provided with the ATA to the power
connector on the ATA. Connect the other end of the power converter to
an AC power outlet.
If you are using a powered Ethernet cable with your 3C10400B ATA, see
the "Using Power over Ethernet with a 3C10400B ATA"
3C10120B cannot use a powered Ethernet cable due to its power
requirements.
2 Connect a Category 5 Ethernet cable to the ATA RJ-45 connector that has
no icon beside it. Connect the other end of the Category 5 Ethernet cable
to the LAN on which the NCP is located.
3 Wait 2 minutes (more on a system with many devices) for the NBX system
to discover the ATA.
4 If the ATA is connected to a fax machine, configure the port for fax
usage:
a Open the NBX NetSet utility and go to Telephone Configuration >
ATA.
b Select the ATA from the list and click its extension.
c Enable the check box labeled Fax Machine, then click Apply.
Configuring an ATA port for fax operation optimizes the performance for
inbound and outbound faxes. If you make a voice call using the ATA
device (for example, if you use the telephone portion of the fax machine),
the quality of the audio may be affected. If you make a VTL call using the
ATA device, the audio may be unusable. If you configure the port for fax
on page 54 for information on system software
.
next. The