Drain Pump Connection - Electrolux 5995421640 Use & Care Manual

Electrolux use & care guide ice maker e15im60e
Hide thumbs

Advertisement

Table of Contents
10

Drain Pump Connection

CONNECTING A DRAIN PUMP
If a gravity drain connection is not available, and you have not purchased the
E15IM60E with factory installed pump, we strongly recommend the use of the
Electrolux EIMP60 drain pump. The Electrolux EIMP60 drain pump is available
through your Dealer, or direct from Electrolux with complete installation instructions.
If a pump other than the Electrolux EIMP60 drain pump is to be used, it must meet
the following specifications:
It must be UL listed and have a UL listed, 120 VAC, 3-wire grounded power
cord.
It must have overall maximum outside dimensions of 8-3/4" wide x 5-3/4"
deep x 7-3/4" high.
It must have a minimum flow rate of 15 gallons per hour at 10 feet of lift.
It must have a sealed sump which does not allow water leakage in the case
of a power outage, restricted drain or pump failure.
It must have a check valve in the discharge line to prevent waste water return
to the pump.
It must have an overflow protection control which will shut off power to the ice
maker in the event of a pump failure.
It must have an operating temperature range of 50°F to 110°F (10°C to 43°C).
CA
CA
UTION
UTION
CAUTION
CA
CA
UTION
UTION
!
In the event of a power outage, restricted drain or pump failure, the failure to use the
Electrolux EIMP60 drain pump or a pump with the above listed specifications, could
result in substantial water leakage and pooling with severe and costly water damage
and related consequential damages and harm.

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux 5995421640

This manual is also suitable for:

E15im60epsE15im60e

Table of Contents