ICE DISPENSER OPERATION & CARE
The ice cube thickness control is factory set for best overall performance. The
factory setting is designed to
maintain an ice bridge of
approximately 1/16" to 1/8" under
normal conditions resulting in a
dimple of approximately 1/4" to 1/2"
in depth (see Figure 28). A fuller
cube with less of a dimple results in
a thicker ice bridge. As the ice bridge
becomes thicker, the tendency for
the cubes to stay together as a slab
increases. A bridge thicker than 1/8"
may cause cubes to over-fill the ice
Disconnect power to the ice maker before making any ice thickness adjustments.
Disconnect power to the unit.
Remove the screws securing the
front access panel (see Figure 29).
1/4" TO 1/2"
ACCESS PANEL SCREWS
1/16" TO 1/8"