Table of Contents
Advertisement
Attaching the stand in the
wall mount position
1. Bring the line cord through the opening
in the stand, then lower the stand into
the slots on the base.
2. Slide the stand into the locked position,
as shown below.
*
We recommend that you use a wall mounting plate
(available at your phone retailer). If wall mounting
without a plate, use the stand as a template for
positioning screws in the wall.
3. Plug the line cord into the wall jack. Line
*
4. Continue routing the cords in the
5. Remove the tab from the base and
6. Pull the base antenna vertical and
7
up the screws on the wall mount plate
with the openings in the stand and slide
the phone down until the mounting
screws hold firmly.
channels on the stand.
reinsert it with the point up. Make
sure the tab is in all the way. Hang
the handset on the tab. If the charge
light does not light up, and the handset
is switched on, the tab has not been
locked into position.
Remove
Retirer
extend it all the way up.
Char
Advertisement
Table of Contents
