Attaching The Stand In The Wall Mount Position - Aastra Maestro 4525 Owner’s Owner's Manual

Attaching the stand in the
wall mount position
1. Bring the line cord through the
opening in the stand, then lower
the stand into the slots on the
base.
2. Slide the stand into the locked
position, as shown below.
* We recommend that you use a wall mounting plate
(available at your phone retailer). If wall mounting
without a plate, use the stand as a template for
positioning screws in the wall.
3. Plug the line cord into the wall
jack. Line up the screws on the
wall mount plate with the
openings in the stand and slide
the phone down until the
mounting screws hold firmly.
4. Continue routing the cords in the
channels on the stand.
5. Remove the tab from the base
and reinsert it with the point up.
Make sure the tab is in all the
way. Hang the handset on the
tab. If the charge light does not
light up, and the handset is
switched on, the tab has not been
locked into position.
6. Pull the base antenna vertical and
extend it all the way up.
7
Remove
Retirer
Charge