Troubleshooting; Please Do Not Return This Product To The Store - Bissell PowerGlide® Pet Bagged Rewind Vacuum User Manual

T
roubleshooting
Vacuum cleaner won't turn on
possible causes
1. Power cord not plugged in
2. Blown fuse/tripped breaker
3. Damaged cord
Vacuum cleaner won't pick up
possible causes
1. Clog in hose or elsewhere in vacuum
2. Filters are dirty
3. Dirt container is full
4. Hose not attached properly
5. Dirt container or upper tank not installed properly
6. Incorrect height adjustment
7. Crack or hole in hose
8. Broken or worn drive belt
9. Rotating floor brush jammed
10. Rotating floor brush bristles worn
tools won't pick up
possible causes
1. Clog in hose or elsewhere in vacuum
2. Filters are dirty
3. Dirt container is full
4. Dirt container or upper tank not installed properly
5. Crack or hole in hose
Visible dirt escaping from cleaner
possible causes
1. Dirt container full
2. Filters missing or installed incorrectly
cord will not retract
possible causes
1. Cord is knotted or twisted
other maintenance or service not included in the manual should be
performed by an authorized service representative.

please do not return this product to the store.

for any questions or concerns, bissell is happy to be of service.
w w w . b i s s e l l . c o m
thank you for selecting a bissell product.
contact us directly at 1-800-237-7691.
WaRning:
To reduce the risk of electric shock, turn power
switch off and disconnect polarized plug from
electrical outlet before performing maintenance
or troubleshooting checks.
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker
3. Refer to a BISSELL authorized service center for repair
or replacement
Remedies
1. Follow instructions on page 11 for clearing clogs
2. Check and clean or replace pre-motor and post-motor filters,
see page 9
3. Empty dirt container
4. Grasp quick reach handle and firmly push hose wand onto
the hose wand base
5. Position correctly and lock in place
6. Adjust powerfoot to correct height setting
7. Check hose and replace if needed
8. Replace drive belt, see page 10
9. Remove brush and clean debris from brush ends
10. Replace brush
Remedies
1. Follow instructions on page 11 for clearing clogs
2. Check and clean or replace pre-motor and post-motor
filters, see page 9
3. Empty dirt container
4. Position correctly and lock in place
5. Check hose and replace if needed
Remedies
1. Empty dirt container
2. Check pre-motor and post-motor filters for correct installation
Remedies
1. Follow instructions on page 7
8 0 0 . 2 3 7 . 7 6 9 1
13