Table of Contents
Advertisement
Installing the virtual media key
To install a virtual media key, complete the following steps:
10. Rotate the rear adapter retention bracket to the closed (locked) position.
11. Reinstall the left-side cover (see "Replacing the left-side cover" on page 101).
12. Lock the left-side cover.
13. Reconnect the external cables and power cords; then, turn on the attached
96
System x3400 M2 Types 7836 and 7837: Installation and User's Guide
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 32.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Unlock the left-side cover.
4. Remove the left-side cover (see "Removing the left-side cover" on page 36).
5. Carefully lay the server on its side so that it is lying flat and facing up.
Note: Be careful and do not drop the server.
6. Rotate the rear adapter-retention bracket to the open (unlocked) position.
7. Remove any adapters that prevent you from accessing the virtual media key
connector on the system board
Note: Make a note of the cabling for later when you reinstall the adapters.
.
8. Align the alignment bracket on the rear of the key with the retention tab on the
system board; then, slide the key down into the virtual media key connector on
the system board until it is firmly seated in place.
9. Reinstall any adapters that you removed earlier.
devices and turn on the server.
Advertisement
Table of Contents
