Internal Cable Routing And Connectors - IBM 783722U Installation And User Manual

3. Press down on the fan until it locks into place; then, close the fan handle to the
4. Install the left-side cover (see "Replacing the left-side cover" on page 101).
5. Lock the left-side cover.

Internal cable routing and connectors

The server uses cables to connect SATA attached, simple-swap SATA, hot-swap
SATA and hot-swap SAS devices to the power supply and to the system board.
Review the following information before connecting power and signal cables to
internal drives:
v The drives that are preinstalled in the server come with power and signal cables
v When you route a cable, make sure that it does not block the airflow to the rear
You can install either a USB or SATA tape drive in the server. The following
illustration shows the internal cable routing and connectors for both the USB tape
drive and the SATA tape drive. It also shows the internal power cable for the optical
drives.
Hot-swap fan
locking position.
attached. If you replace any drives, remember which cable is attached to which
drive.
of the drives or over the microprocessor or DIMMs.
Chapter 2. Installing optional devices
85