Installing a power supply
To install a power supply, complete the following steps.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the
power-control button becomes active.
1. Align the screw holes in the power supply cage pivot bracket with the
2. While you support the power supply cage, install the three screws that secure
3. Connect the cables from the power supply to the system board and all internal
4. Rotate the power-supply cage assembly back into the server. Press the
corresponding screw holes on the rear of the chassis.
the power supply to the chassis.
components.
power-supply cage release tab and rotate the power-supply cage assembly into
the chassis.
Chapter 2. Installing optional devices
81